ASYSTEMS NT 2504
VERSATILE DIGITAL NETWORK AMPLIFIER WITH DSP PROCESSING
1000 Watt 4-Channel Networking Amplifier with DSP Processing
Feature
- 4-channel amplifier – 250 watts per channel
- 4 ohm and constant voltage models available (70V or 100V)
- 4-in x 4-out sophisticated matrix mixing makes routing easy
- Optional Dante networking (model no. DT44)
- Internal sampling rate set at 48kHz
- 24-bit A/D D/A conversion
- Extensive internal signal processing
- Remote user control through Asystems Windows software
- Real-time error notifications via email reporting function
- DSP Processing:
- Automatic Mixing
- Limiters
- 10-band EQs
- 2- and 3-way Crossovers
- Output Delay
- Password protected user accounts
Specifications
- Low Z, Stereo Mode, all channels driven (RMS Power Ouput Per Channel)
- 8Ω, 20Hz-20kHz 1%THD: 150W
- 4Ω, 20Hz-20kHz 1%THD: 250W
- Low Z, Bridge Mode, all channels driven (RMS Power Output)
- 8Ω, 20Hz-20kHz 1%THD: 500W
- Distributed Output (RMS Power Output Per Channel)
- 70V, 100V, 20Hz-20kHz 1%THD: 250W
- Models Available: 4Ω and 8Ω / 70.7V Constant Voltage / 100V Constant Voltage
- System
- Amp Circuitry: D
- Input Sensitivity: 1.42 Vrms
- Distortion (SMPTE-IM): <0.02%
- Noise (Unweighted 20 Hz – 20 kHz below rated power): 107 dB
- Damping Factor: >300 @ 8Ω
- Frequency Response: 20 Hz-20kHz +-1dB; -3dB: 5Hz-50kHz
- Input Impedance: 20 kΩ balanced; 10 kΩ Unbalanced
- Cooling: Variable Speed Fans – front to rear flow
- Indicators: -40dB,-6dB, -3dB, Clip/Protect, Bridge (one per two-channel group), Power, Disable, Standby/Unlock, Protect
- Front Panel: AC power switch & gain control
- Control
- Operation Mode: Stereo / Bridge Mono
- Voltage Gain: 40 x (32 dB)
- Network Control: Built-in Ethernet, 10/100 Mbit/s
- Connections
- Input (Line-level): 4 x 3-pin Euroblock Connectors
- Output (Powered): 4 x 2-pin Euroblock Connectors
- Protection Circuitry
- Amplifier Protection: Totally Short / Open / Overheat / VLF / RF protection / Mismatched loads stabilize the transition
- Load Protection: On / Off squelch / AC coupling / Triac crowbar (each channel)
- Power Supply
- Power Consumption: 375W
- Power Requirements (Region Dependent)100 – 120VAC, 220 – 240VAC, 50/60Hz